2nd tunnel on macosx

[Hinnack]

I want to connect to two different VPNs.

sudo /usr/sbin/tincd -n net1
sudo /usr/sbin/tincd -n net2

using tincd 1.0.13 I get Address already in use as above

regards

Henrik

2010/7/14 Mike Bentzen <mike at goodlook.com.au>

> On 14/07/2010, at 9:05 PM, Hinnack wrote:
>
> Hi,
>
> maybe I am blind, but how to start 2 tunnels on OSX?
>
> using a different device I get:
> /dev/tap1 is a Generic BSD tap device
> add net 192.168.1.0: gateway 10.9.99.4
> route: writing to routing socket: File exists
> add net 10.150.0.0: gateway 10.9.99.4: File exists
> Can't bind to 0.0.0.0 port 655/tcp: Address already in use
>
>
> I think you are trying to start multiple tinc daemons.
> Once one daemon has started listening on port 655, you can't run more
> daemons on the same port. It's already in use.
>
> Try what Guus suggested if you want to connect two nodes belonging to the
> same VPN.
> If you're trying to make tinc join another separate VPN, you need to add
> another netname.
>
> This link gives some good information about this scenario under the
> NETWORKS heading.
> http://tinc-vpn.org/documentation/tinc.conf.5
>
>
> Mike
>
>
> Unable to create any listening socket!
> Terminating
>
> using same device I get:
> tincd 1.0.13 (Jul  7 2010 07:42:33) starting, debug level 0
> Could not open /dev/tap0: Resource busy
> Terminating
>
> is this a problem related to unsupported Interface variable on OSX?
>
> regards
>
> Henrik
> _______________________________________________
> tinc mailing list
> tinc at tinc-vpn.org
> http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
>
>
>
> _______________________________________________
> tinc mailing list
> tinc at tinc-vpn.org
> http://www.tinc-vpn.org/cgi-bin/mailman/listinfo/tinc
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.tinc-vpn.org/pipermail/tinc/attachments/20100714/5260e7bd/attachment.htm>