* "routera" configuration for tinc (the master router):
> >cat tinc.conf
> Name = routera
-> Device=/dev/net/tun
-> TCPOnly = on
> Mode = switch
> Interface = vpn6
>
> >cat tinc-up
> #!/bin/sh
> #Enable tinc
-> ip -6 link set vpn6 up mtu 1280 txqueuelen 1000
-> ip -6 addr add 2001:db8:beef::1/64 dev vpn6
-> ip -6 route add 2001:db8:beef::/48 dev vpn6
+> ip -6 link set $INTERFACE up mtu 1280 txqueuelen 1000
+> ip -6 addr add 2001:db8:beef::1/64 dev $INTERFACE
+> ip -6 route add 2001:db8:beef::/48 dev $INTERFACE
> #Static routing table
> ip -6 route add 2001:db8:beef:2::/64 via 2001:db8:beef::2
> ip -6 route add 2001:db8:beef:3::/64 via 2001:db8:beef::3
> ip -6 route del 2001:db8:beef:3::/64 via 2001:db8:beef:::3
> ip -6 route del 2001:db8:beef:4::/64 via 2001:db8:beef:::4
> #Disable tinc
-> ip -6 route del 2001:db8:beef::/48 dev vpn6
-> ip -6 addr del 2001:db8:beef::1/64 dev vpn6
-> ip -6 link set vpn6 down
+> ip -6 route del 2001:db8:beef::/48 dev $INTERFACE
+> ip -6 addr del 2001:db8:beef::1/64 dev $INTERFACE
+> ip -6 link set $INTERFACE down
>
* "routerb" configuration for tinc (the other non-master routers will be like this one):
> >cat tinc.conf
> Name=routerb
-> Device=/dev/net/tun
-> TCPOnly = yes
> Mode = switch
-> Interface = vpn6
> ConnectTo = routera
+> Interface = vpn6
>
> >cat tinc-up
> #!/bin/sh
-> ip -6 link set vpn6 up mtu 1280
-> ip -6 addr add 2001:db8:beef::2/64 dev vpn6
+> ip -6 link set $INTERFACE up mtu 1280
+> ip -6 addr add 2001:db8:beef::2/64 dev $INTERFACE
> ip -6 route add default via 2001:db8:beef::1
>
> >cat tinc-down
> #!/bin/sh
> ip -6 route del default via 2001:db8:beef::1
-> ip -6 addr del 2001:db8:beef::2/64 dev vpn6
-> ip -6 link set vpn6 down
+> ip -6 addr del 2001:db8:beef::2/64 dev $INTERFACE
+> ip -6 link set $INTERFACE down
5. You can use [radvd](http://www.litech.org/radvd/) or [Quagga](http://www.quagga.net/) to perform [stateless address autoconfiguration](http://www.ietf.org/rfc/rfc2462.txt) on your LAN. This is an example zebra.conf for LAN autoconfiguration (don't forget to enable the zebra daemon):
> ipv6 forwarding