X-Git-Url: https://www.tinc-vpn.org/git/browse?p=tinc;a=blobdiff_plain;f=doc%2Ftinc.conf.5.in;h=b3b94f8f668eea70bfbb94bebe4ab44483433410;hp=0ad3da3de8d3c2361dc007560f861dae21ca646d;hb=ec316aa32e8567395a88c4583007f01ffae008ce;hpb=a5f899a9794f215e8174455ead04862a2c14a5b1

diff --git a/doc/tinc.conf.5.in b/doc/tinc.conf.5.in
index 0ad3da3d..b3b94f8f 100644
--- a/doc/tinc.conf.5.in
+++ b/doc/tinc.conf.5.in
@@ -1,4 +1,4 @@
-.Dd 2008-12-22
+.Dd 2009-03-05
 .Dt TINC.CONF 5
 .\" Manual page created by:
 .\" Ivo Timmermans
@@ -394,7 +394,7 @@ Either the PEM format is used, or exactly one of the above two options must be s
 in each host configuration file,
 if you want to be able to establish a connection with that host.
 
-.It Va Subnet Li = Ar address Ns Op Li / Ns Ar prefixlength
+.It Va Subnet Li = Ar address Ns Op Li / Ns Ar prefixlength Ns Op Li # Ns Ar weight
 The subnet which this tinc daemon will serve.
 .Nm tinc
 tries to look up which other daemon it should send a packet to by searching the appropriate subnet.
@@ -416,6 +416,13 @@ Read a networking HOWTO/FAQ/guide if you don't understand this.
 IPv6 subnets are notated like fec0:0:0:1:0:0:0:0/64.
 MAC addresses are notated like 0:1a:2b:3c:4d:5e.
 
+.Pp
+A Subnet can be given a weight to indicate its priority over identical Subnets
+owned by different nodes.  The default weight is 10. Lower values indicate
+higher priority. Packets will be sent to the node with the highest priority,
+unless that node is not reachable, in which case the node with the next highest
+priority will be tried, and so on.
+
 .It Va TCPOnly Li = yes | no Pq no
 If this variable is set to yes,
 then the packets are tunnelled over the TCP connection instead of a UDP connection.