X-Git-Url: https://www.tinc-vpn.org/git/browse?p=tinc;a=blobdiff_plain;f=README;h=a8fff1766d8a6930753b8858d6374b8f505dedf3;hp=243f0efe8d310849d68eb360874602c68df8c731;hb=8c267d3d558ac97a4ce7381a37abb6cc4b46b133;hpb=a8f415e67fd316d929f9b9e6661e0d3d66fc197b diff --git a/README b/README index 243f0efe..a8fff176 100644 --- a/README +++ b/README @@ -1,10 +1,10 @@ -This is the README file for tinc version 1.0.2. Installation +This is the README file for tinc version 1.0.10. Installation instructions may be found in the INSTALL file. -tinc is Copyright (C) 1998-2003 by: +tinc is Copyright (C) 1998-2009 by: -Ivo Timmermans , -Guus Sliepen , +Ivo Timmermans, +Guus Sliepen , and others. For a complete list of authors see the AUTHORS file. @@ -55,8 +55,8 @@ should be changed into "Device", and "Device" should be changed into Compatibility ------------- -Version 1.0.2 is compatible with 1.0.1, 1.0 and 1.0pre8 but not with older versions -of tinc. +Version 1.0.10 is compatible with 1.0pre8, 1.0 and later, but not with older +versions of tinc. Requirements @@ -115,8 +115,7 @@ Support for routing IPv6 packets has been added. Just add Subnet lines with IPv6 addresses (without using :: abbreviations) and use ifconfig or ip (from the iproute package) to give the virtual network interface corresponding IPv6 addresses. tinc does not provide autoconfiguration for IPv6 hosts, if you need -it use radvd or zebra. Tunneling IPv6 packets only works on Linux, FreeBSD, -Windows and possibly OpenBSD. +it use radvd or zebra. It is also possible to make tunnels to other tinc daemons over IPv6 networks, if the operating system supports IPv6. tinc will automatically use both IPv6