X-Git-Url: https://www.tinc-vpn.org/git/browse?p=tinc;a=blobdiff_plain;f=README;h=8f76b15067d29f31b61ba00e54b320db9861898e;hp=1f523d786f3630c1b30a07615ec6f85e011f2b6d;hb=44834d030464bbe1f7733caba8d96c678f1d6cf2;hpb=cf2be574948fdd02db0503d9639d3b6e268dd4ff

diff --git a/README b/README
index 1f523d78..8f76b150 100644
--- a/README
+++ b/README
@@ -1,7 +1,7 @@
-This is the README file for tinc version 1.0.8. Installation
+This is the README file for tinc version 1.0.11. Installation
 instructions may be found in the INSTALL file.
 
-tinc is Copyright (C) 1998-2007 by:
+tinc is Copyright (C) 1998-2009 by:
 
 Ivo Timmermans,
 Guus Sliepen <guus@tinc-vpn.org>,
@@ -55,7 +55,7 @@ should be changed into "Device", and "Device" should be changed into
 Compatibility
 -------------
 
-Version 1.0.8 is compatible with 1.0pre8, 1.0 and later, but not with older
+Version 1.0.11 is compatible with 1.0pre8, 1.0 and later, but not with older
 versions of tinc.
 
 
@@ -115,8 +115,7 @@ Support for routing IPv6 packets has been added. Just add Subnet lines with
 IPv6 addresses (without using :: abbreviations) and use ifconfig or ip (from
 the iproute package) to give the virtual network interface corresponding IPv6
 addresses. tinc does not provide autoconfiguration for IPv6 hosts, if you need
-it use radvd or zebra. Tunneling IPv6 packets only works on Linux, FreeBSD,
-Windows and possibly OpenBSD.
+it use radvd or zebra.
 
 It is also possible to make tunnels to other tinc daemons over IPv6 networks,
 if the operating system supports IPv6.  tinc will automatically use both IPv6