Enable AutoConnect by default.

[tinc] / doc / tinc.conf.5.in

diff --git a/doc/tinc.conf.5.in b/doc/tinc.conf.5.in
index ed9709a..6897ba6 100644 (file)
--- a/doc/tinc.conf.5.in
+++ b/doc/tinc.conf.5.in
@@ -114,7 +114,7 @@ If
 .Qq any
 is selected, then depending on the operating system both IPv4 and IPv6 or just
 IPv6 listening sockets will be created.
-.It Va AutoConnect Li = yes | no Po no Pc Bq experimental
+.It Va AutoConnect Li = yes | no Po yes
 If set to yes,
 .Nm tinc
 will automatically set up meta connections to other nodes,
@@ -177,7 +177,7 @@ line).
 .Pp
 If you don't specify a host with
 .Va ConnectTo
-and don't enable
+and have disabled
 .Va AutoConnect ,
 .Nm tinc
 won't try to connect to other daemons at all,
@@ -312,6 +312,10 @@ This is less efficient, but allows the kernel to apply its routing and firewall
 and can also help debugging.
 Incoming packets using the SPTPS protocol are dropped, since they are end-to-end encrypted.
 .El
+.It Va FWMark Li = Ar value Po 0 Pc Bq experimental
+When set to a non-zero value, all TCP and UDP sockets created by tinc will use the given value as the firewall mark.
+This can be used for mark-based routing or for packet filtering.
+This option is currently only supported on Linux.
 .It Va Hostnames Li = yes | no Pq no
 This option selects whether IP addresses (both real and on the VPN) should
 be resolved. Since DNS lookups are blocking, it might affect tinc's