Allow environment variables to be used for Name.

[tinc] / doc / tinc.conf.5.in

diff --git a/doc/tinc.conf.5.in b/doc/tinc.conf.5.in
index 8034418..560ae47 100644 (file)
--- a/doc/tinc.conf.5.in
+++ b/doc/tinc.conf.5.in
@@ -394,6 +394,19 @@ while no routing table is managed.
 .It Va Name Li = Ar name Bq required
 This is the name which identifies this tinc daemon.
 It must be unique for the virtual private network this daemon will connect to.
+The Name may only consist of alphanumeric and underscore characters.
+
+If 
+.Va Name
+starts with a
+.Li $ ,
+then the contents of the environment variable that follows will be used.
+In that case, invalid characters will be converted to underscores.
+If
+.Va Name
+is
+.Li $HOST ,
+but no such environment variable exist, the hostname will be read using the gethostnname() system call.
 
 .It Va PingInterval Li = Ar seconds Pq 60
 The number of seconds of inactivity that
@@ -564,12 +577,11 @@ variables can be specified.
 Subnets can either be single MAC, IPv4 or IPv6 addresses,
 in which case a subnet consisting of only that single address is assumed,
 or they can be a IPv4 or IPv6 network address with a prefixlength.
-Shorthand notations are not supported.
 For example, IPv4 subnets must be in a form like 192.168.1.0/24,
 where 192.168.1.0 is the network address and 24 is the number of bits set in the netmask.
 Note that subnets like 192.168.1.1/24 are invalid!
 Read a networking HOWTO/FAQ/guide if you don't understand this.
-IPv6 subnets are notated like fec0:0:0:1:0:0:0:0/64.
+IPv6 subnets are notated like fec0:0:0:1::/64.
 MAC addresses are notated like 0:1a:2b:3c:4d:5e.
 
 .Pp