-.Dd 2008-12-22
+.Dd 2009-03-05
.Dt TINC.CONF 5
.\" Manual page created by:
.\" Ivo Timmermans
.Va PrivateKeyFile
specified in the configuration file.
+.It Va ProcessPriority Li = low | normal | high
+When this option is used the priority of the tincd process will be adjusted.
+Increasing the priority may help to reduce latency and packet loss on the VPN.
+
.It Va TunnelServer Li = yes | no Po no Pc Bq experimental
When this option is enabled tinc will no longer forward information between other tinc daemons,
and will only allow nodes and subnets on the VPN which are present in the
in each host configuration file,
if you want to be able to establish a connection with that host.
-.It Va Subnet Li = Ar address Ns Op Li / Ns Ar prefixlength
+.It Va Subnet Li = Ar address Ns Op Li / Ns Ar prefixlength Ns Op Li # Ns Ar weight
The subnet which this tinc daemon will serve.
.Nm tinc
tries to look up which other daemon it should send a packet to by searching the appropriate subnet.
IPv6 subnets are notated like fec0:0:0:1:0:0:0:0/64.
MAC addresses are notated like 0:1a:2b:3c:4d:5e.
+.Pp
+A Subnet can be given a weight to indicate its priority over identical Subnets
+owned by different nodes. The default weight is 10. Lower values indicate
+higher priority. Packets will be sent to the node with the highest priority,
+unless that node is not reachable, in which case the node with the next highest
+priority will be tried, and so on.
+
.It Va TCPOnly Li = yes | no Pq no
If this variable is set to yes,
then the packets are tunnelled over the TCP connection instead of a UDP connection.
projects / tinc / blobdiff