Use variable length arrays instead of alloca().

[tinc] / README

diff --git a/README b/README
index c98d282..80cf0a6 100644 (file)
--- a/README
+++ b/README
@@ -1,9 +1,9 @@
-This is the README file for tinc version 1.0.2. Installation
+This is the README file for tinc version 1.0.13. Installation

 instructions may be found in the INSTALL file.
 
 instructions may be found in the INSTALL file.
 

-tinc is Copyright (C) 1998-2004 by:
+tinc is Copyright (C) 1998-2010 by:

 
 

-Ivo Timmermans <ivo@tinc-vpn.org>,
+Ivo Timmermans,

 Guus Sliepen <guus@tinc-vpn.org>,
 and others.
 
 Guus Sliepen <guus@tinc-vpn.org>,
 and others.
 


@@ -55,8 +55,8 @@ should be changed into "Device", and "Device" should be changed into
 Compatibility
 -------------
 
 Compatibility
 -------------
 

-Version 1.0.2 is compatible with 1.0.1, 1.0 and 1.0pre8 but not with older versions
-of tinc.
+Version 1.0.13 is compatible with 1.0pre8, 1.0 and later, but not with older
+versions of tinc.

 
 
 Requirements
 
 
 Requirements


@@ -115,8 +115,7 @@ Support for routing IPv6 packets has been added. Just add Subnet lines with
 IPv6 addresses (without using :: abbreviations) and use ifconfig or ip (from
 the iproute package) to give the virtual network interface corresponding IPv6
 addresses. tinc does not provide autoconfiguration for IPv6 hosts, if you need
 IPv6 addresses (without using :: abbreviations) and use ifconfig or ip (from
 the iproute package) to give the virtual network interface corresponding IPv6
 addresses. tinc does not provide autoconfiguration for IPv6 hosts, if you need

-it use radvd or zebra. Tunneling IPv6 packets only works on Linux, FreeBSD,
-Windows and possibly OpenBSD.
+it use radvd or zebra.

 
 It is also possible to make tunnels to other tinc daemons over IPv6 networks,
 if the operating system supports IPv6.  tinc will automatically use both IPv6
 
 It is also possible to make tunnels to other tinc daemons over IPv6 networks,
 if the operating system supports IPv6.  tinc will automatically use both IPv6