Remove GraphDumpFile from the manual and manpages.

[tinc] / doc / tinc.conf.5.in

diff --git a/doc/tinc.conf.5.in b/doc/tinc.conf.5.in
index 423b2ae..350a410 100644 (file)
--- a/doc/tinc.conf.5.in
+++ b/doc/tinc.conf.5.in
@@ -114,6 +114,15 @@ If
 .Qq any
 is selected, then depending on the operating system both IPv4 and IPv6 or just
 IPv6 listening sockets will be created.
+.It Va AutoConnect Li = Ar count Po 0 Pc Bq experimental
+If set to a non-zero value,
+.Nm
+will try to only have
+.Ar count
+meta connections to other nodes,
+by automatically making or breaking connections to known nodes.
+Higher values increase redundancy but also increase meta data overhead.
+When using this option, a good value is 3.
 .It Va BindToAddress Li = Ar address Op Ar port
 If your computer has more than one IPv4 or IPv6 address,
 .Nm tinc
@@ -288,18 +297,6 @@ Incoming packets are always sent to the TUN/TAP device, even if the packets are
 This is less efficient, but allows the kernel to apply its routing and firewall rules on them,
 and can also help debugging.
 .El
-.It Va GraphDumpFile Li = Ar filename
-If this option is present,
-.Nm tinc
-will dump the current network graph to the file
-.Ar filename
-every minute, unless there were no changes to the graph.
-The file is in a format that can be read by graphviz tools.
-If
-.Ar filename
-starts with a pipe symbol |,
-then the rest of the filename is interpreted as a shell command
-that is executed, the graph is then sent to stdin.
 .It Va Hostnames Li = yes | no Pq no
 This option selects whether IP addresses (both real and on the VPN) should
 be resolved. Since DNS lookups are blocking, it might affect tinc's
@@ -393,11 +390,6 @@ The private RSA key of this tinc daemon.
 It will allow this tinc daemon to authenticate itself to other daemons.
 .It Va PrivateKeyFile Li = Ar filename Po Pa @sysconfdir@/tinc/ Ns Ar NETNAME Ns Pa /rsa_key.priv Pc
 The file in which the private RSA key of this tinc daemon resides.
-Note that there must be exactly one of
-.Va PrivateKey
-or
-.Va PrivateKeyFile
-specified in the configuration file.
 .It Va ProcessPriority Li = low | normal | high
 When this option is used the priority of the 
 .Nm tincd